Sometimes, your plumbing appliances are a total mystery. How DOES your toilet work? What parts are there and why are they needed? At Casey’s, we want to take the mystery out of your plumbing and shine a little light on how they work, so that you can be prepared and educated about what you need. So, without further ado, we present:
How Your Toilet Works
1. Handle, Tank, Rim – the outside parts of your toilet. These are self-explanatory.
2. Fill Valve – the device that fills your toilet tank after every flush. If you have a constantly running toilet, a broken or faulty fill valve is a likely culprit.
3. Filler Float – A ball-shaped device that plays a role in open and closing the fill valve.
4. Overflow Tube – directs tank water into the bowl after it reaches a certain level.
5. Flush Valve (or Flapper) – The rubber ball or bulb that lays flush against the discharge hole at the bottom of the tank that allows water to flow quickly into the bowl.
6. Bowl – Fairly self-explanatory. You can guess what it’s for, right?
7. Siphon – The pipe at the bottom of the bowl that, when the flush valve is activated, pulls waste away from the bowl.
These are the basic parts of a toilet. Here is how your toilet flushes (from: FactsFacts.com)
“When the Flush Lever is pushed it pulls up on the Chain, which in turn pulls up the Flush Valve. This exposes the large discharge hole at the bottom of the tank allowing water to rush quickly into the toilet bowl. There are two types of Flush Valves. Older Flush Valves were rubber Balls (see circular insert in figure). Modern Flush Valves are called Flappers. The Ball or Flapper Bulb is filled with air, so it wants to float, but the weight of the water on top of it clamps/seals it tightly against discharge hole. But, once it is pulled away from the hole, water flows under it and it floats. This holds it open, away from the discharge hole.
Immediately after a flush begins the water level in the tank starts to go down, so the Float starts to go down. [It’s called a Float because it’s a hollow ball floating on the surface of the water.] The Float, by way of the rod attached to it, opens the Fill Valve, and water from the house water pipe (through the Stop Valve) begins to flow into the tank. So, water’s coming in and going out at the same time. But, it’s going out much faster than it’s coming in, so the tank empties into the bowl quickly. When it’s almost empty the Flapper can no longer float and falls onto the discharge hole sealing/closing it again. Now that the discharge hole is closed the water coming in through the Fill Valve starts refilling the tank. While the tank is refilling a small amount of water is also going from the Fill Valve through the Refill Tube into the Overflow Tube. The Overflow Tube empties directly into the toilet bowl. This water raises the water level in (refills) the bowl. If it weren’t for the Refill Tube there would be only a small amount of water in the bottom of the bowl.”
One Big Thing You Will Want To Know:
Where your toilet’s water shut off is. An overflowing toilet is gross, no matter what. Knowing where your toilet shut off is can save you a really disgusting cleanup after the fact. Toilet water shut offs are normally located behind the tank, a few inches or so off the ground. Remember: righty-tighty (close the shut off) lefty-loosey (open it.)
So, now you know how your toilet works. You are empowered!
Hint: You can always call us for advice, 24 hours a day, seven days a week. We’ll here to help: